• Thermostat Location.2 Carrier’s 7-day, 5/2-day, or 1-day programmable commer- Wiring Requirements.2 cial thermostat control is a wall-mounted, low-voltage control Two-Piece Installation. • Wire length should not exceed 1,000 ft. NOTE: Carrier sensor part no. 33ZCT55SPT would be used for • For wiring the control module to the equipment, the dis- remote space sensing averaging. Sensors must be used as a sin. During thermostat installation provide sufficient excess wiring behind the mounting plate. Coil the wiring creating a service loop and place in mounting box or behind the wall to remove strain against the terminal strip. The listing you're looking for has ended. Carrier Commercial 33CS2PP2S-02 Thermostat Edge Pro Heat Pump Manual On CD. Condition: Used. Ended: Nov 07. NOTE: Read the entire instruction manual before starting the installation. — Equipment Type. — Clean Filter Timer Adjustment. A33-9162 Fig. 1 — Locking Tab Location Fig. ![]() Find a suitable indoor mounting location for equipment control module. The module should be mounted on or near the HVAC equipment. A33-9166 Fig. 6 — Pigtail Connection Fig. 8 — Equipment Control Module Mounting 10. Connect red wire of the pigtail to V+ RED terminal. • RELAYS OAT/RRS SRTN RETURN CONTACT SEPARATE RC/RH BY CONNECT O/W2/B TO USER BREAKING BLACK INTERFACE JW6 ON CONTROL MODULE BOARD. Template blog lost saga phoenix wing. A33-9170 LEGEND — Outdoor Air Temperature Sensor — Remote Room Temperature Sensor Fig. 10 — Control Module Connector Block Terminals only, the equipment control module does not need to be leveled for proper operation) and mark wall through two mounting holes. Attach display module body to equipment control module CONFIGURATION by first setting the module on at top of equipment control Press To Enter and Exit Configuration Mode — module and then snapping the bottom corners of display and hold OCCUPIED button for approximately 10 seconds. Module into place. • (r), or the average of local and remote that energizes its reversing valve (O/W2/B) in heating. Sensors (Lr). The Carrier sensor 33ZCT55SPT would be used NOTE: The WSHP will always energize the reversing valve in for remote space sensing and averaging. Settings are L, r, or Lr. • set to OF, then Auto mode is not available. Allowable selections NOTE: This configuration is only available if Option 34 is set to are On and OF (off). The default is On. Od or if a valid sensor is connected. • 3 — Without Unlock Code Configuration settings are OF (off), 20, 25, 30, 35, 40, 45, 50 F (–6.7, –3.9, –1.1, 1.7, 4.4, 7.2, 10 C) and On. The entire keypad will be locked. When the user presses a but- ton, the backlight turns on to maximum brightness for 10 sec- When set to OF (off), heating always starts in low stage (Y1) onds but none of the thermostat operating parameters will be. • When set to OF (off), the Daylight Savings Time Function NOTE: In a non-heat pump application, if emergency heat is disabled. Is off, the second stage of heat will show “heat on” and “2” in the bottom right of the thermostat display. The first time the UP or DOWN button is pressed, the value of this selection changes from OF (off) to 1. • button is kept pressed until the count reaches zero, the reset will Setting the Clock, Calendar, Daily Schedule, be performed. To set the clock, press the SET and Holiday Settings — button once. The clock will be displayed at the bottom center of When the value reaches zero, the heat set point will display the screen.
0 Comments
Leave a Reply. |